Honda Prelude 1997-2001 Catback Exhaust
(will fit all models, but will not fit SH model)
Fits:
1997-2001 Honda Prelude Base Coupe 2-Door
*SH model has a longer length header. Our midpipe will be too long to fit on the SH, so you will need to cut and remove about 4 inches of pipe from our resonator midpipe to fit. Cut out 4 inches and re-weld the flange. Bends are the same*
This
Yonaka Motorsports catback exhaust system is made of fully polished
stainless steel, with 2.5" OD mandrel bended piping, and a 4.25" tip.
Expect a quiet, clean, deep hum, without that irritating mid range raspy
sound.
Direct bolt-on fit to OEM. All installation hardware is included.
Disclaimer:
Recommended for off-road use only. Check with your local ministry of
transportation in regards to exhaust regulations.